Boat Pics

[petermarcus]

I wish I had a pic of the boat when I first dragged it from under the tree. One of the tires on the trailer had sunk into the sand up to its rim, and when I pulled it out, the rubber had disintegrated and I had to get a new tire.

Here's the engine after being dunked mostly underwater a couple years before.




After taking the engine out of the boat, there was a lot of external rust




Inside the flywheel container was the skeleton of a frog or toad. Guess it was a little moist in there.


Here was what was left of the water pump


While disassembling the engine though, I was surprised to see the external rust was just that -- external. The inside of the engine was pristine, even after being dunked and sitting unused for years. Shows how good these engines really are.


I tore the engine down to the block. At the very top is the block with the crank in front of it and the cam to the left (the silver wheel) and the carb next to it. The pistons are in front of the red engine stand with the bearings to the right. Then oil pan toward the front of the pistons with the outdrive (propeller and such) in front of that, alternator (which ended up being fine) to the right surrounded by the belt, and the starter motor (which was one solid piece of useless rust) in front of that, and the exhaust manifold in the very foreground.


All of that ended up being tested and maybe 30% of it was replaced (which was a lot less than I had guessed). The block was blasted and honed, the head was shaved to match, and the end result was a shiny engine!

(I couldn't find a mounting arm for the alternator just to the right of the belt, so it's still the same rusty piece of steel, but it gives a good contrast to what was fixed on the outside)

I didn't try to tackle the deck until the engine was ready, and it's in sad shape right now.




The plan is to cut out the seat boxes flush to the deck, take the rest of the deck out, then replace it with plywood that has 3 or so coats of epoxy on it (thus, waterproof). Then, instead of carpet, there's a marine vinyl that's non-skid and doesn't soak up water (or fish fluids) and I'll probably cover the plywood with that.

Comments

[billijean.livejournal.com]

omg. that stresses me out. I'd never get that all back together.

The frog/toad skeleton is way cool :)

[petermarcus.livejournal.com]

I took 134 pictures of me taking the engine apart. I had shop manuals and such with a lot of diagrams, but those pictures helped more than anything else.

[billijean.livejournal.com]

Ah. Well. I wouldn't do that. I'd jump in and make a mess and then go, Oh shit. Or, I'd be organised and document and then M would "Clean up" and yeah.

But you are very clever (not that we didn't already know that). :)

[petermarcus.livejournal.com]

Thomas Edison used to take things apart to see what made them tick (including, ironically, watches), and he always put all the parts on his table in the order in which he took them apart, so he could always reverse it. I tried to do the same. Then, over the course of the year, with garages always being in a state of flux, everything got shuffled. But! I took pics!

[kristylicious.livejournal.com]

I'm with you Blue ... I'd be sitting on the floor confused going OMG ... RONNNNNNNNNN (he's way more patient than I am).

[petermarcus.livejournal.com]

Hee, patience is necessary. But, look at all the high school dropouts who can take a corvette apart and put it back together again blindfolded. It really isn't rocket science at all, there are big pieces that only go a certain way....but a knack for machines helps a lot.